Congratulations on your purchase of your new Subaru, Baja Tonneau Bed Cover!  We hope you agree that this cover completes the unique styling of this versatile automobile.  Our purpose was to design a stylish, locking, weather resistant cover that could be quickly removed and reinstalled without tools.

 

We have empirically tested the use of this cover and feel it is safe and practical under normal use; however, a little common sense - please…

 

The existing curves of the Baja bed capture and hold the cover in place; therefore, it must sit down flat.  Please, do not overload the exterior bed while using the OZZBROS LLC Bed Cover. If items to be carried do not easily fit under the OZZBROS LLC Bed Cover - remove the OZZBROS LLC Bed Cover until items have been transported.  The cover is designed to be able to be quickly removed and stored off the vehicle or carried inside, behind the front seats of the Baja.  Care must be taken when removing the cover and storing it to not damage the vinyl cover. 

 

To ensure safe use of the OZZBROS LLC Bed Cover:

·        Always lock the OZZBROS LLC Bed Cover in-place. 

·        Never overload the Baja exterior bed when using the OZZBROS LLC Bed Cover.

·        Never travel down the road unless the OZZBROS LLC Bed Cover is locked down. 

 

Your OZZBROS LLC Bed Cover comes with a limited one-year warrantee.  Your OZZBROS LLC Bed Cover is warranted against failures in materials and workmanship for one year from the date of purchase.  Rips in the vinyl cover from misuse are not covered.  To receive warrantee consideration the bottom registration must be completed and mailed back to OZZBROS LLC Tonneau Systems with a copy of your original, dated sales receipt.  The vinyl used is a marine grade - UV rated product.  For best life we recommend treating the vinyl cover once a month with a UV blocking protectant, and lubricating the lock cylinder with petroleum based lubricant every three months.

 

To mount the OZZBROS LLC Bed Cover – First, slide the front deck lid (small one) in front of the roll bars, set the rear edge against the roll bar bases and gently push the front edge down until it sets down flat.  Second, set the back deck lid on the side rails of the bed, lift the rear up 30 degrees above flat and gently slide the back deck forward until the retaining strip sets under the front deck – then lower deck into place.  Properly installed, the back edge of the deck will fit inside the back tailgate and all edges of the two covers will sit down flat.  Fasten the lock, and the OZZBROS LLC Bed Cover is installed.

 

To mount the lock strike plate to the tailgate – From inside the bed, under the installed decks (front and back), hang the strike plate from the lock so that the strike plate sets flat against the closed back tailgate with some “play”.  Center the strike plate within the range of “play” and permanently mount in-place with the provided self tapping screws.  See Lock Installation Instruction sheet.  Verify lock alignment and adjust placement if necessary.  We recommend asking your dealer to complete the strike plate installation for you. 

 

Please detach below and mail to OZZBROS LLC Tonneau Systems, PO Box 392, Stilwell, KS  66085 with copy of sales receipt.

 

Owner:

Name: __________________________

Address: ________________________

City: ___________________________

State: ____________________

Zip Code: __________

 

Date of Purchase: _________________

 

Did you read and understand the limitations of use of your OZZBROS LLC Bed Cover?

 _________Yes _________No

Dealer purchased from:

Name: __________________________

Address: ________________________

City: ___________________________

State: ____________________

Zip Code: __________